简要说明：

可连接传感器	2，3或者4个
通道数	5个
传感器输入接口	9针
数据和控制输出接口	25针
电源供电	115VDC 60Hz
可选模块	4-20mA, 0-10V, 双设定值报警，峰值保持，

概述

传感器信号放大器是将传感器输出信号进行精密放大，线路内部进行稳压、恒流供桥、电压电流转换，阻抗适配，线性补偿，温度补偿等，将力学量转换成标准电流、电压信号输出。

美国Transducer Techniques TIO-3000集成放大器和信号调理仪功能，用于信号源和读出设备之间的信号调理器件，如衰减器、前置放大器、电荷放大器以及对传感器或放大器进行非线性补偿的电平转换器件。

The TIO-3000 System was originally designed to perform precision summing on 2, 3 , or 4 load cell signals for weighing applications. Development has progressed into accessory modules with considerable versatility for user defined configurations in a compact economical five (5) slot system with built-in meter and channel selector.

Please see below for more information on the four available plug in modules and for available system configurations.

特性

详情请联系我们

参数

Meter: 3 1/2 or 4 1/2 digit

Sensor Input: 9 pin D connector

Data / Control Output: 25 pin D connector

Size (Inches): 12 wide x 7.5 high x 8 deep

Power: 115 VAC 60 Hz

Fuse: 250 mA

Weight / Force Analog Data

Pressure Current Loops

Strain Peak Capture

Deflection (.5 ms Response Time)

Control (Alarms)

Quick Look Display

Amplifier Type: Bipolar differential

Gain Adjustment: 75 to 1000

Input Impedance: 50 megaohm minimum

Output Voltage: 0 to +-10 volts, less with sum

CMR: 10 dB min., DC to 15 Hz

Noise and Ripple: Less than 10 mV

Nonlinearity: .05% of full scale

Compliance: .1% of full scale

Frequency Response: DC to 16 Hz

Bridge Resistance: 120 to 1000 ohm

Bal Range (350 ohm): 25% of output, minimum

Shunt Calibration: Single point, local

Sensor Wiring: 6 wire shielded

Excitation Type: Constant 8 VDC

up to 100 mA

Load Regulation: .1% max for

订货

订货型号

TI0-3000 N/A   5 Chan. Industrial Chassis

TI0-3000-4.5   with 4.5 (19999) Digit Meter

TM0-3    Amp/Conditioner Module

TM0-3A   Amp/Cond 4-20MA Module

PKD-3    Peak Hold Module

DSP-3    Dual Setpoint Alarm Module

SUM-3    Precision Sum Module 0-10V

SUM-3A   Precision Sum Module 4-20mA

型号

相关型号

DPM-2

LCA-9PC

LCA-RTC

TMO-2

TMO-2A

尺寸图