简要说明：

测量范围	最大1000 Kg (2200 lbs)
测量材料尺寸	最大30 mm (1.25")
过载保护	200%
精度	± 1.5% Full Scale or better
用途	适用于更大尺寸材料的张力检测，例如电缆，电线和绳索

概述

张力仪是测量丝网受到拉力作用时其内部与固定丝网接触体之间的相互牵引力大小的仪器。张力仪有机械式和电子式两种，测量张力的单位用牛顿/厘米表示。张力也可以用相对数值来表示。厘米张力仪就是用相对数值表示张力的一种，是通过张力仪自身重量使丝网下沉的深度的数值(毫米)来计算，张力数值可从指示盘上直接得到，或者从控制盘上间接得到。张力仪有手工操作和机械操作两种。张力仪是检验丝网印版质量的重要的检测仪器。为保证得到制版要求的张力，在绷网过程中或绷网后都要使用张力仪测量。

德国Honigmann专注于卷材张力检测和张力控制有超过60年历史，是世界最大张力测量仪表生产商。旗下热销产品有张力计136-3适用于更大尺寸材料的张力检测，例如电缆，电线和绳索。

16 Ranges Avail - Up to 1000 Kg (2200 lbs)
Cable Diameters - Up to 30 mm (1.25")

The new Honigmann 136-3 Hand-held Tension Meter is designed for use on larger diameter materials such as cables, large diameter wire, wire ropes and similar materials up to 30mm (1.25").

Schmidt136-3 It is designed to minimize the effects of different material rigidities when measuring on a variety of material sizes and also features a unique "tri-tens" system where the material can be threaded through the 3 rollers in 3 distinct patterns.

Each threading pattern provides a different multiplying factor. For instance, assuming the Threading Pattern "D" below, (where all 3 rollers are on the same side), versus Threading Pattern "E", where one roller is on one side and 2 rollers are on the other side. Pattern "E" provides a multiplier of approximately 5x compared to threading Pattern "D".

This permits the user to use the most appropriate threading pattern based on the tensions required for a specific material. In other words, the same hand-held sensor can be considered to have 3 different capacities, (depending upon threading pattern "D", "E" or "F). For example, when using a 400 mm wide outer roller bracket.

? 100 Lb Capacity when using "D"

? 25 Lb Capacity when using "E"

? 15 Lb Capacity when using "F"

特性

• One sensor for three measuring ranges Tritens?

• Easy material threading

• Unaffected by changes in material diameter and rigidity

• Minimal material deflection

• Tension ranges up to 1000 Kg (2200 lbs)

  
  

参数

订货

订货型号

136-3

型号

相关型号

D-485

TM-353

136-3P

尺寸图