VGD485-48V蓄电池适配TCM电动叉车FB15-7平衡重叉车电瓶48V485 Ah

以下为行业相关信息，非广告内容，请选择性观看：

Precautions for electric forklift battery as the source of forklift traction

?

The forklift battery, as the traction force, is the main power source of the forklift. The price component is an important tributary of the whole vehicle. In the process of use, the shell is broken more or less due to improper use. In this way, if the monomer is replaced, the forklift battery as the traction force of the enterprise may be increased. It is the main power source of the forklift. The price component is an important tributary of the whole vehicle. In the process of use, the shell is broken more or less due to improper use, In this way, if the monomer is replaced, the enterprise cost may be increased. The battery shell of the electric forklift is made of polypropylene plastic. Because the raw materials are not easy to prepare, the process is complex, and the repair time is long, it can not meet the needs of market maintenance. When heating at high temperature, carbon fire, electric hair dryer, and electric furnace can be used. As long as it is not hot, there is no fear of explosion. As the main equipment of handling machinery, the driving force of forklift comes from the lead-acid battery. When the fault code is generated on the line, it will affect the working state of the battery and even affect the service life of the battery.

?

When heating the valve hole, cover it with a rubber cover, put on a asbestos cloth, and add water to protect the valve hole from deformation. The water supply for this kind of battery shall be full, and there shall be no flowing water in a single cell. The operation steps of the welding method are to find out the approximate range of the fracture first; Tighten the liquid filling cap, clean the surface with a brush dipped in water, dry the water with a temperature adjustable plastic welding gun (hereinafter referred to as the welding gun), and seal the vent hole with scotch tape or label paper. Better prepare another set of liquid filling cap, and seal the vent hole with the plastic rod heated by the welding gun, so that it is more convenient to use during maintenance; Put the side of the fracture upward, clean the area around the fracture with a brush dipped in water, and then dry the water with a welding gun; Select the position of the welding gun, heat the plastic rod to melt it and apply it evenly around the crack, press the prepared patch on the crack and continue heating for one or two minutes. Stop heating and cool it after it is completely bonded. Unscrew the filling cap, remove the transparent tape on the filling cap and check the liquid level. If there is leakage or lack of liquid, add electrolyte. If it is not urgently needed after repair, charging and density adjustment shall be supplemented; In case of emergency, it can be directly loaded for use. Finally, if the forklift battery single shell cannot be repaired, only replace the single